So i am at a point in the build where i want to get my perches welded up. But i am not to sure about the pinion angle. Right now i have it tilted toward the t-case.
my ds angle reads:=21 degrees
My flange reads:20 degrees
t-case flange:3 degrees
Does this seem close the two are with in a degree to eachother what are some magic numbers here?
I am planing on buying a nice cv driveshaft later on when i get dual cases. but want to have the pinion somewhat set in its place.
For now i have a stock 92 4runner ds mounted up for mach up. and in the process of making a sqaure tube drive shaft for a temporary solution





Any input would be helpful. especially the bad <img src="/forums/images/graemlins/cheers.gif" alt="" />