Quote
Like Joe said, the 208 adapter works fine with the D300. You will need to replace the D300 input shaft with a 27 spline one to mate to the 700R4. I got mine from JB Conversions. They have a couple different lengths for different adapters, but they were familiar with this setup and got me the right one.

Quote
Other than a o-ring seal I don't think he's had any issues with it.


Yeah, don't forget that one <img src="/forums/images/graemlins/scared.gif" alt="" />

<img src="/forums/images/graemlins/cheers.gif" alt="" />Andre


Ok, is the dana300 shaft a female shaft that slides on to the 700r4 shaft? I've never seen a dana300 out of a vehicle. The adapter that came off of the original np233 (Push Button 4wd) is only a 5 bolt pattern <img src="/forums/images/graemlins/confused.gif" alt="" /> I've never seen one of those either, until now. Is there not enough material on the 208 adapter to re-drill the 6th hole?

I'll check out jb conversions I can pick up a 208 adapter for like $25

Thanks guys for the help.

Chad

-Chad