Can the turning diameter on the '07 tacoma's be reduced?

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Can the turning diameter on the '07 tacoma's be reduced? [Re: Climber66] #822023 06/30/07 05:11 PM

Joined: Oct 2002

Posts: 4,482

Phoenix, Arizona

azrain

Emeritus Staffer and Moderator

From what I recall from the last time I was under the front end, no. IIRC they are on hard stops.

Entire Thread
Subject	Posted By	Posted
Can the turning diameter on the '07 tacoma's be reduced?	Climber66	06/30/07 01:20 AM
Re: Can the turning diameter on the '07 tacoma's be reduced?	azrain	06/30/07 05:11 PM
Re: Can the turning diameter on the '07 tacoma's be reduced?	BIGBURLYNAKEDMAN	07/02/07 05:42 AM
Re: Can the turning diameter on the '07 tacoma's be reduced?	RichinROA	07/02/07 02:51 PM
Re: Can the turning diameter on the '07 tacoma's be reduced?	Climber66	07/06/07 01:31 AM

Moderated by 4x4Wire, Dandeman, kewlynx

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.528s Queries: 16 (3.525s) Memory: 0.6005 MB (Peak: 0.6335 MB) Data Comp: Off Server Time: 2026-06-16 05:00:53 UTC
Valid HTML 5 and Valid CSS