Adjusting 2.6L lifters/valves

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Adjusting 2.6L lifters/valves [Re: powerRam50] #824344 07/11/07 06:44 PM

Joined: Jan 2001

Posts: 13,649

Helen , GA

fasteddy

Web Wheeler

If you set the crank on tdc #1, you can adjust 4 of the valves. Then turn one full rev back to the mark and you can set the other 4. I use .007 and .010 on int. and exh. per some manual I read a long time ago.

Not responsible for advice not taken...

Entire Thread
Subject	Posted By	Posted
Adjusting 2.6L lifters/valves	jerzboy	07/11/07 04:16 PM
Re: Adjusting 2.6L lifters/valves	powerRam50	07/11/07 04:53 PM
Re: Adjusting 2.6L lifters/valves	fasteddy	07/11/07 06:44 PM
Re: Adjusting 2.6L lifters/valves	torquemonster	07/11/07 07:03 PM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.471s Queries: 16 (3.468s) Memory: 0.5996 MB (Peak: 0.6325 MB) Data Comp: Off Server Time: 2026-06-03 00:45:53 UTC
Valid HTML 5 and Valid CSS