I have done everything suggested.Still no luck.It has new distrib,distrib cap,plugwires,fuelfilter,coil with ignition transistor,fuelpump,engine electrical relay,ECM heatsensor,ignition switch,Starter. I have pulled all wire harnesses apart. And ran current thru each wire to make sure no breaks in wires.Checked vacuam lines for cracks and breaks.I put meter on the ECM it flashed ECM heat sensor changed it.Started ran short time died no start, no spark Checked computer again said crank angle sensor code thats in new distr. If im not mistaking.Checked all wires and connectors.Cleaned connections.Had to stop working pulled batt out for my pick up.Back to work.Put battery back in checked ECM with meter its flashing short steady pulses this is good.Raider starts runs about 5 min DIES.Check code on meter still short steady pulses.This is good but still no start.Can this maybe be the computer.I have had the cover off ECM dont see no browning on boards ,no corrosion,no funny smells.I have cleaned all grounds and even added grounds from batt to coil,batt to ECM,batt to starter.I dont want to ramble.I find my self doing that a lot lately.I hate to bowdown and take to dealer.Anyone got ECM for 3.0 1989 Dodge Raider they want to sell <img src="/forums/images/graemlins/lol.gif" alt="" />.Or somemore ideas that havent been tried. <img src="/forums/images/graemlins/zombie.gif" alt="" /> Thanks for all your ideas.This site really does ROCK.....