Things to check:
1. When at TDC, put balancer & plastic cover on... Does it line up to 0 deg or 15 deg?
If 15 deg, alignment of belt or slipped balancer pulley... If not, #2
2. When you install dist, are you aligning all marks like you are supposed to? Is it seating all the way down flange to base?Is the adjuster stud in the center of adjustment slot? If not, keep trying... It truly seems to be off 1 tooth. I had this issue till I found the dist alignment procedure. If not, #3

3. Check & recycle all plug connections with di-electric grease. Might be a bit of corrosion in there. If not #4.


4.... Scare the bejesus out of it with a cutting torch... Mine mysteriously ran fine after that ( actually found loose plug).

Ed

Yankneck = Yankee ingenuity with Redneck stupidity.
"How can I break it better?"
89 Raider 3.0 w/ 31's for now