Throw out bearing insalled wrong? or bad slave?

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Throw out bearing insalled wrong? or bad slave? [Re: mlclark] #834259 09/06/07 03:31 AM

Joined: May 2001

Posts: 229

Seattle, Wa. USA

blue rig

Wheeler

are you certain that you did not install the clutch disk upside down? Sadly I have done that and had the same results...different vehicle. Ryan

90 Trooper 2.6 -Daily driver/backyard tractor-

Entire Thread
Subject	Posted By	Posted
Throw out bearing insalled wrong? or bad slave?	throwin_roost	09/05/07 10:31 PM
Re: Throw out bearing insalled wrong? or bad slave?	mlclark	09/05/07 10:40 PM
Re: Throw out bearing insalled wrong? or bad slave?	blue rig	09/06/07 03:31 AM
Re: Throw out bearing insalled wrong? or bad slave?	throwin_roost	09/06/07 09:48 PM
Re: Throw out bearing insalled wrong? or bad slave?	Jim_Paget	09/07/07 04:02 AM

Moderated by 4x4Wire, houlster, jezeric, Jim_Paget, strawmyers

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.882s Queries: 16 (3.880s) Memory: 0.6013 MB (Peak: 0.6343 MB) Data Comp: Off Server Time: 2026-06-15 13:44:30 UTC
Valid HTML 5 and Valid CSS