Well for those who don;t know I'm in the middle of putting a 4D56 (2.3 turbo diesel) into my '85 Pickup. Fairly straight forward so far, just working on electrical and other little things right now.

Supposedly, it will bolt straight in using the original Montero motor mounts and the original clutch setup ( not sure if this is the Ranger flywheel, pressure plate, etc. or the Montero one). It doesn't seem this way in my case.

Since I am doing the swap on a pickup, I have a cable clutch rather than the hydraulic setup. The ranger had a hydraulic setup, so the pressure plate and flywheel are too thick to go into my transmission. I would use the Mitsu setup I have, but the flywheel is a good bit lighter and the diesel starter won't reach to engage the starter ring. The motor mounts don't look like they will work either, although I thought they were the same between the pickup and Montero.

Long story short, I need someone with access to CAPS to help me get a lot of part numbers, since the Dodge dealer isn't being helpful and the nearest Mitsu dealer is an hour away.

I need numbers for:

-1985 Mighty Max SP with a 2.6 (VIN JA7FK44E9FP405112)
Flywheel, pressure plate, clutch disk, throwout bearing, motor mounts

-1985 Mitsubishi Mighty Max SP with 2.3 4d56 (sorry, no VIN)
Starter motor,Flywheel, pressure plate, clutch disk, throwout bearing, motor mounts

-1985 Montero (or any other 1st gen w/ 2.6, again no VIN)
Motor Mounts

Thank you so much for any help, and sorry for the insanely long post.