I'm starting to plan out the budget for pretty much rebuilding my Jeep from the ground up. My goal is a good, but not top of the line off-roader, with some okay road performance. There are many parts I'm pretty sure about, but one thing that I'm having a hard time wrapping my mind around is my pinion angle. I've read how to set it and such, but if I do a large enough suspension lift, then maybe rotate my D300 and get a longer tranny, it seems like I'd have to angle my rear axle up quite a bit, and then angle my t-case down to match it like
[Linked Image]
but how is the t-case angling or lowering accomplished? The only thing I've found so far is a t-case drop kit like
[Linked Image]
but it doesn't look like that hardware could re-angle or even lower my t-case without needing the engine and tranny lowered also.
It's probably a very simple explanation, but I'm at a loss.
Thanks for any help!
-Ron <img src="/forums/images/graemlins/zombie.gif" alt="" />

Last edited by wax66; 10/17/07 06:04 PM.