I just found the directions for the installation of a t-case lowering kit and all it does is lower your skid plate with spacers. I guess that may benefit me at some point, since that would tilt the whole engine->tranny->t-case line back a little, ending up with the t-case tilted down towards the rear axle, allowing me a higher pinion angle. Of course, everything is a trade-off, so I'd have less ground clearance in the middle, but it may be worth it. I'll see when I get my axles and lifts.
-Ron <img src="/forums/images/graemlins/zombie.gif" alt="" />


'82 CJ7, Original 258
Unknown and undoubtedly ungodly amount of miles.