Eric

I read your thread, thought about posting my problem there, but as you had solved your problem I decided to start a new thread. I checked dsmisc.com, even with the $=ú rate as it is the Aus works out cheaper. I emailed the seller & he has confirmed compatibility. Which screw are you refering to, do you have a picture ? just in case I decide to try that test

MontyMcV

I pulled the ISC Wed evening, by tourch light, all the coil resistance values were good (between 28.5 & 29.4 ohms) cold, the truck has not been used for a while. I knew I had an idle problem just never got round to chasing it as the truck has not been used, there be a lesson I should have chased it when I has the truck off the road. <img src="/forums/images/graemlins/frown.gif" alt="" />
I chanced a throttle body off ebay a couple of weeks ago (ú10 inc P&P <img src="/forums/images/graemlins/kewl.gif" alt="" /> ) but it's from the later years (96 onward) so the ISC is different. The hoses too are run different. Anyone know if that throttle body will be OK on the 93 engine??

I intend to try & check the coil values on the truck, after I get home from work.