pulling intake manifold

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

pulling intake manifold #845567 11/05/07 09:14 PM

Joined: Nov 2007

Posts: 2

Fishingfool Offline

Need a Spot

cant get the intake manifold off. trying to do a head gasket - timing chain job on '87 22RE engine. removed all the 8mm bolts and 2 8mm nuts and tapped on it with block and hammer. no go. i dont want to crack the aluminum casting with brute force...

Entire Thread
Subject	Posted By	Posted
pulling intake manifold	Fishingfool	11/05/07 09:14 PM
Re: pulling intake manifold	4Crawler	11/05/07 09:19 PM
Re: pulling intake manifold	Fishingfool	11/06/07 12:08 AM
Re: pulling intake manifold	toyneedshelp	11/06/07 03:09 AM
Re: pulling intake manifold	kewlynx	11/06/07 03:16 AM

Moderated by 4Crawler, 4x4Wire, kewlynx

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.525s Queries: 15 (3.523s) Memory: 0.6002 MB (Peak: 0.6332 MB) Data Comp: Off Server Time: 2026-06-12 09:51:30 UTC
Valid HTML 5 and Valid CSS