My buddy has a 3 inch BL kit from an old 4 runner. Contains 14 pucks and a couple blocks. He is going to pretty much give it too me. It appears that the pucks and hardware are all ill need. Anyone off the top of thier head have a count of how many pucks the 2nd Gen Rodeo has? Are they all the same diameter? Any other parts I will need other than the fab on the steering joint?

I would take it apart myself and find out but for the next month or two its a daily so that is not an option.

I am willing to bet this has been covered before, my search combinations did no reveal any useful info though.

On a side note. Finally talked to Matt at Indy. You all were right, good folks over there. Thanks again for the info. <img src="/forums/images/graemlins/lol.gif" alt="" />

GO EERS!

Not sure on the 2nd gen, but I am going to assume it is similiar at least to the 1st gen.

The 1st gen has 12 pucks......8 of the 2" diameter size and 4 of the 3" diameter. The rear ones are the ones that are the 3" diameter (2 at each corner) The rest are all 2" diameter, although I think a 3" diameter would still work in most places.

I hope that helps...at least somewhat.

http://www.mjw.com/amigo/tech/frame.htm

amigo at the top rodeo at the bottom

Thanks yall, I am going to give it a go, if it works great. if not then ill start over a square one.