got all parts from American Street Rod( http://www.amstreetrod.com./CatalogIndex.php4 ).
hose i used is is -4AN flexible stainless braided hose made by/for ASR.... for brake or clutch use. i used info from the following thread in determining the parts. but the tech line at ASR was very helpful also.

http://www.4x4wire.com/forums/showf...p;amp;sb=5&o=186&fpart=1

Also, i separated the trans from the motor tonight. sure enough, there appears to be no pilot bushing in the 3.4L i installed. or, if there is one, it is larger diameter. right now i can only tell by sticking a finger in through the clutch pieces and into back of the motor. will know more when i get a little daylight time to work on this. i went ahead and got the $60 harbor freight tranny jack.....made removal a whole lot easier than the last time.