The front drivers side of my axle tube is slightly bent where it comes out of the pumpkin. It is the short tube, and it is bent up slightly, but it is definitely noticeable by the camber of the wheel. I'm guessing it happened when I hit a stump while snow wheeling, that I didn't see over a little hill, and covered in powder, but it may be caused from a combination of things, because I have probably hit rocks harder than that, just on the trails. The question is, is it possible to get the axle pulled, or pressed, to be straightened, then re enforced with welded on gussets. I know it Isn't too major, because since I have noticed it, I have put on over 300 miles, and have been driving for over 4 weeks, but I don't want to do any 4 wheeling until I get it fixed. Also, i have a feeling that that is what is making my diff seals leak. It is too late tonight, but I will take, and post some pictures tomorrow if i can get around to it.