does this help?

FRONT BRAKE ROTOR
Removal
1) Raise vehicle and remove wheels. Disconnect brakeline from caliper (if necessary). Remove caliper.
2) On models with free wheeling hub, set control handle to
FREE position. On all models, remove hub cover, bolt/washer and hub body. Use tapered punch to open slits of conical washers. Remove axle shaft snap ring (if equipped).
3) Straighten tabs of outer lock washer. Using Spindle Socket (09607-60020), remove lock nut, lock washer and adjusting nut. Remove thrust washer and outer bearing. Remove axle hub and rotor. Remove grease seal and inner bearing. Press hub bolts out of axle hub. Remove
retaining bolts, and separate rotor from hub.

Installation
To install, reverse removal procedure. Adjust wheel bearings.
See appropriate article:
* SUSPENSION - FRONT - 2WD.
* SUSPENSION - FRONT - 4WD.
Tighten all bolts to specification. See TORQUE SPECIFICATIONS

If you give me your email address I could send the pertinent file for removal of hubs with pics from 95 4 runner Manual.
Also, have you checked the 93 FSM link ?
93 FSM