I like the way Nathan is approaching the transfer. By using the Mits reduction for the front eliminates much fabrication time and has him to one custom spline set and adapter. If more reduction is desired it can be done in the rear 231.
I am using a 231 in the center and a stock SR transfer in the rear, for mine this is more appropriate since I am using a 6 speed manual so an adapter is needed anyways and I place a greater emphasis on road use so I am retaining the AWD feature.
I like Nathan's approach, too, and it's certinly eliminates the need for the adapter from the trans to the t-case and the required 'spud' shaft. So far the adapter hasn't been much of an issue but finding 4340 heat treated in less than a 12' section is turning into a real pain in the rear. <img src="/forums/images/graemlins/frown.gif" alt="" /> Gonna end up at McMaster-Carr and then have it heat treated here in Denver, I suspect. <img src="/forums/images/graemlins/frown.gif" alt="" />
I think if I wanted to retain AWD, though, I'd stick with the NP231 in the front and put a NP241 in the rear.
But, that's where Nathan and I differ in approaches. I'm trying to get RID of anything Mitsu manual transmission related - including eventually the transmission. Nathan is trying to retain as much of the factory Mitsu design and parts as is reasonably possible.
Both of the approaches are fine. But the drive behind mine is that I put 40,000 (abusive) miles on a year and I can't have my Sport down for repairs for even a week without dissrupting my business. (it's going to be hard enough to go down for the couple days it'll take to swap t-cases next month) That means that I have to be able to get parts ASAP and they need to be cheap and repairs have to be quick and as relativly painless as possible. Example: I can rebuild an NP231 (now) in probably not more than an hour and the rebuild kit is less than a couple hundred dollars and it's available from everywhere. It takes at least an hour to tear down a Mitsu t-case, you have to have a couple specialty tools and I KNOW the rebuild parts are a LOT more expensive than $200! <img src="/forums/images/graemlins/scared.gif" alt="" />
If I were just building a crawler and was driving something else for work, etc. I'd do it Nathan's way. Cheaper and if you check the PDF on my site - Nathan's setup is a LOT less complicated! Definitely an easier approach from what I've read of his posts. <img src="/forums/images/graemlins/kewl.gif" alt="" />
But, if you're shooting for long term simple and cheap maintenance the dual NP231 setup is it. And, you'll get (slightly) better gas milliage from the NP231 - less rotating internals. <img src="/forums/images/graemlins/smile.gif" alt="" />
Edward