LOL, I was just logging on to give an update for the day, and I find the thread has been bumped for me. <img src="/forums/images/graemlins/smile.gif" alt="" />
I finished up the rear cab mounts tonight. They had to be moved rearward and out. I used solid plate to space them outward. The cab is now solidly bolted to the frame in all six locations. I might be able to raise the fuel tank an inch or two for extra clearance.
I also decided to start checking out some of the other stuff. I hooked up the steering shaft, which was a direct swap. I also dropped the engine and transmission in place. The SOHC 3.0 is a much tighter fit than the 2.6 was (duh <img src="/forums/images/graemlins/lol.gif" alt="" />). At one point I started to get concerned that I might have mis-measured. A body lift might be required to clear the hood.
It looks like the shifter hole is almost perfectly located too. If I'm lucky, I'll be able to use the original center console with little to no modifications. That is, other than an extra shifter somewhere. <img src="/forums/images/graemlins/wink.gif" alt="" />
I haven't made much progress with the doubler t-case. I think I have the adapter plate pretty much done. I still need to complete the shifter. I think I might get a bit more complicated and try to re-use one of the position switches so I can detect if it is in low or not.
I was planning on SAS this while I was at it, but I might have to push that off for a bit. I need to move in June and I need to start saving up more cash to do so. <img src="/forums/images/graemlins/baby.gif" alt="" /> Worse case, I should still be able to wheel it with IFS. <img src="/forums/images/graemlins/shiner.gif" alt="" />