Bad Vibrations

Print Thread

Rate Thread

Re: Bad Vibrations [Re: BobRowe] #877374 03/26/08 04:25 AM

Joined: Oct 2002

Posts: 72

Charlotte, NC

Junkie

Getting the Wheeling Fever

new u-joints. The 9" rear is a brand new unit from currie ent, so I don't think that is it.

I did notice the transmission stabalize bushing & bolt was not tight. You know the where it is bolted on the drivers side through the belly pan. Do you think that not being bolted down securely could cause this? I have new parts & bushings I was going to install, just haven't gotten around to it yet.

Entire Thread
Subject	Posted By	Posted
Bad Vibrations	Junkie	03/26/08 03:46 AM
Re: Bad Vibrations	BobRowe	03/26/08 04:02 AM
Re: Bad Vibrations	Junkie	03/26/08 04:25 AM
Re: Bad Vibrations	BobRowe	03/26/08 01:52 PM
Re: Bad Vibrations	jstritec	03/26/08 05:36 PM
Re: Bad Vibrations	BobRowe	03/26/08 11:27 PM
Re: Bad Vibrations	Junkie	03/27/08 02:00 AM
Re: Bad Vibrations	shtkicker	03/29/08 03:59 AM
Re: Bad Vibrations	Junkie	03/31/08 12:02 AM
Re: Bad Vibrations	BobRowe	03/31/08 12:53 AM
Re: Bad Vibrations	80CJ	03/31/08 07:08 AM
Re: Bad Vibrations	Junkie	03/31/08 11:38 PM
Re: Bad Vibrations	BigJim	03/31/08 11:44 PM
Re: Bad Vibrations	Junkie	04/01/08 12:11 AM
Re: Bad Vibrations	reepersteve	04/01/08 01:01 AM
Re: Bad Vibrations	Bigbird79	04/01/08 05:11 AM
Re: Bad Vibrations	DBL_DTY97TJ	04/01/08 03:31 PM
Re: Bad Vibrations	Junkie	04/03/08 02:23 AM
Re: Bad Vibrations	DBL_DTY97TJ	04/03/08 02:29 PM
Re: Bad Vibrations	Junkie	04/06/08 03:10 PM
Re: Bad Vibrations	Bigbird79	04/06/08 03:18 PM
Re: Bad Vibrations	4x4Wire	04/01/08 04:21 AM

Moderated by 4x4Wire

Hop To

4x4Wire Social: