Blend Proportioning Valve

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Blend Proportioning Valve [Re: DirtDriver] #877860 03/28/08 08:03 PM

Joined: Jan 2007

Posts: 44

Savannah, GA

85Montero

Getting the Wheeling Fever

Don't want to take something loose I dont have to. The line to the back is already leaked empty as I had a back wheel cylinder go bad. So I replaced all the hardware in the back so the two rear hard lines were already removed and blown out. The old fluid looked like coffee.Just wondering...no biggie.

Entire Thread
Subject	Posted By	Posted
Blend Proportioning Valve	85Montero	03/28/08 04:03 PM
Re: Blend Proportioning Valve	fasteddy	03/28/08 05:50 PM
Re: Blend Proportioning Valve	DirtDriver	03/28/08 07:08 PM
Re: Blend Proportioning Valve	85Montero	03/28/08 08:03 PM
Re: Blend Proportioning Valve	fasteddy	03/28/08 09:00 PM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.505s Queries: 16 (3.502s) Memory: 0.6009 MB (Peak: 0.6339 MB) Data Comp: Off Server Time: 2026-06-07 14:16:52 UTC
Valid HTML 5 and Valid CSS