Burnt valve 3VZE

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: Burnt valve 3VZE [Re: Anse] #880178 04/11/08 05:03 AM

Joined: Apr 2000

Posts: 4,230

Roseville, CA, Gateway to the ...

OOP'S

Roll Me Over

I would drop the pan and pull the rod and main bearing caps to take a peek at the bearings. Also check the cylinder walls to see how much of a ridge ring there is, that will tell you the condition of the cylinders.

David Fritzsche
1990 Ex-Cab V-6,5-speed, with a few mods
04.5 CTD Dodge 2500 Ram--Tow Rig
Roseville, CA

"Serenity through Sobriety"

Entire Thread
Subject	Posted By	Posted
Burnt valve 3VZE	Anse	04/11/08 12:36 AM
Re: Burnt valve 3VZE	OOP'S	04/11/08 05:03 AM
Re: Burnt valve 3VZE	Snowtoy	04/11/08 08:27 AM
Re: Burnt valve 3VZE	Anse	04/11/08 03:45 PM
Re: Burnt valve 3VZE	Snowtoy	04/11/08 09:03 PM

Moderated by 4Crawler, 4x4Wire, kewlynx

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 5.006s Queries: 16 (3.513s) Memory: 0.6008 MB (Peak: 0.6338 MB) Data Comp: Off Server Time: 2026-06-05 08:22:08 UTC
Valid HTML 5 and Valid CSS