All I am waiting for is a throw out bearing and it is getting bolted down. I have basically everything new and installed other tha n the engine mounted to the trany. New altenator, battery, cables, ignition coil, dist cap, rotor, wires, plugs, sensors(knock, temp, O2 and oil pressure), water pump, flywheel, clutch, radiator, fuel pump, fuel lines, coolant lines, vaccum lines, power steering pump and lines. I am reusing the throttle body & exhaust manifold but I did clean them both up a bit and switched out the screws on the TPS. The throttle body seemed to be operating great before I decided to jump off the cliff(although I know I might have to adjust the TPS).

Again, the engine is sitting on the lift waiting for me to slap it in which does not cause a void in the warranty but if I don't get the stuff done by a certified mechanic after installation then it is history.

Thanks for the advise!