Yep, I wasn't very specific, sorry.
The output shaft wobbles which I took as meaning it needs the bearing/seal replaced. I will check to make sure the nut is properly torqued first. If I do need to replace the bearing is there anything else that I should replace or inspect while I'm in the t-case. I've never torn down a t-case before so its all new to me.

As for the rear axle, I'd say everything is in need or repair. Each hub will wobble along with a lot of play on the pinion flange as well. You should hear this thing when I'm drivin down the road. It's not tire noise, just sounds like dry bearings, also there is like a rattling/jingling noise when I am coasting, coming from the axle.

Hope this helps to clear things up a bit. I think its safe to say that just about everything needs inspected and maybe replaced. Just lookin for some pointers since in all the years I've been workin on these things I've never tackled the driveline at all.

Thanks