OK I have been thinking about the direction to go in that will best suit my application and am at the point where I need to make a decision on Springs. I want my daily driver to provide me with a "decent ride" but articulation or travel and a 5" or so lift is equally important to me and am thinking that a Spring Over conversion is the way to go to meet both of these objectives. When it comes to fabrication, welding and machining I have the skills and resources needed to relocate spring and shackle mounts as needed. Eventually when my finances allow I plan to upgrade to bigger better axles front and rear but for now will need to live with the Dana 30 front and Corporate Axle in the rear so my question is it feasabale to go forward with the spring over with the exsisting axles and if so are stock YJ springs a good way to go or would an aftermarket spring provide better performance.