85 jeep cj7 6cyl 258
My timing seemed a little off so I got the timing light and turned the distributor until everything sounded good and correct degree setting was set. I killed it and it back fired, so I waited a minute and started it back up. It sounded good. Killed it and tried again a few minutes later and it turned over but would not start. I assumed I had turned distributor too much so I turned it back to original position and tried to start it again. Turned over but would not start. I thought something might have happened to starter solenoid, so disconnected negative cable and replaced starter solenoid. Now it won't do anything. Turn key and nothing. Put other solenoid back on, still nothing. Battery is 100% according to battery tester, but no lights, either. Is there a main power fuse somewhere or maybe the computer MCU went out. Any clues?