White Lightnin has a brand new braking system front to rear except the equalizer. The fronts bled out fine but I cannot get anything, fluid or air, out of the rears. I started with the longest run to the rear but after 10 minuntes of no progress, I switched to the front. I then went back to the rears and still got nothing. Do ya think the equalizer is bad or is there a reset of sorts to free what I assume is a piston inside the eq. block? I also bled the master cylinder first. When I went to refill the cylinder reservoirs, I noticed what looked like a fine gray particulate in the new fluid. Would this indicate a problem or just some honing residue left over. At this point, I dont remember if the M/C was new or rebuilt but I am betting on new. Any feedback is greatly appreciated. <img src="/forums/images/graemlins/notooth.gif" alt="" />