Quote
i think it might have a little to do with your torsion bars too. 3/4 of an inch seems a little tight but if you dont hit them when ur going over a speed bump i guess ur alright. if u wanna find out if ur hitting get a little grease and put it on ur bump stop and if there ends up being a smudge on ur control arm u might wanna crank up ur torsion bars a couple of turns.


Other direction. Down.
Or hit it all with a plasma cutter and leaf or link it.

It doesn't sound all that bad to me. Alignment shops sometimes fiddle with the tbars to get the camber right, also. I had cranked my bars to fit 32s and installed low profile bumps and could just get my fingers in there without getting them stuck. The ride was fine imho, too.

~Adam


96 T100: D44, lockers and stuff