I have two of what you are asking about, I can take pictures on Monday.
you have to buy about 80 bucks worth of cable.
I think I bought 20 feet of black and 12 feet of red.
I think that you would only need 12 of black and 8 of red.
I had not done it before and didn't want to end up with a 5 foot piece that was 6 inches short, if you know what I mean.

for the ends I had to go to a welding supply place.

I used, first a cable TV end crimper then used a dull chisel to really bend them in, then I soldered them.

figuring out the warn 5 wire control took a little work with the ohm meter as I didn't want it to short out.

in cab I have an on off switch that also shuts down the out side controller. so no one can come up and short the correct poles and get the winch to work.
the second is a double pull double throw temporary switch that actually winds the winch in and out.

we both love the in cab controls.
and if you are alone you can also just plug the hand controll into the front of the truck.

also I used the side cable connection to run the truck wireing and the top poles for the winch connection.