Here are some photos (I hope) of the Gen I LWB set-up.

The first photo shows underneath the rear side panel (driver's side). The far right hole is where the 2nd row seat belt lives, the center hole is for the MASSIVE 15 watt speaker, the far left hole is where the 3rd row shoulder belt would live. It's "nut hole" is the exact same size as the "nut hole" for the 2nd row belt.

[Linked Image]

This picture shows the rear upper mount hole (the one in the center), which is NOT the same size as the seat belt bolt. The hole would need to be drilled out about 30%. This same hole exists in the SWB rigs. Sorry for the dark pic, but there was too much other light for the flash to trigger.

[Linked Image]

This last image shows the knock-out in the upper panel of the LWB. It is NOT in the correct position for the needed hole.

[Linked Image]

Last edited by WagonMaster; 11/02/08 04:30 AM.