1997 Mazda halfshafts

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Re: 1997 Mazda halfshafts [Re: hazy_daze] #925057 01/13/09 05:49 PM

Joined: Jan 2001

Posts: 11,595

Cincinnati, OH

Adam F

Forum Moderator

Usually I have to remove the bottom ball joint, but leave the tie rod end and upper ball joint attached. That will allow me to swing the whole knuckle out of the way to pull the shaft through.

88 4R, 350 V8, R150 5 speed Sold <...uot; />
97 4R, stock, daily driver
98 Sienna, kid and dog hauler, wife's ride

Entire Thread
Subject	Posted By	Posted
1997 Mazda halfshafts	Brown81CJ5	01/11/09 04:50 PM
Re: 1997 Mazda halfshafts	Adam F	01/11/09 05:46 PM
Re: 1997 Mazda halfshafts	Brown81CJ5	01/12/09 01:45 AM
Re: 1997 Mazda halfshafts	Adam F	01/12/09 03:53 PM
Re: 1997 Mazda halfshafts	hazy_daze	01/13/09 04:49 PM
Re: 1997 Mazda halfshafts	Adam F	01/13/09 05:49 PM
Re: 1997 Mazda halfshafts	hazy_daze	01/13/09 05:58 PM
Re: 1997 Mazda halfshafts	Adam F	01/13/09 09:38 PM

Moderated by 4x4Wire, 52degrees, Adam F, Axe Man, kewlynx

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.578s Queries: 16 (3.576s) Memory: 0.6087 MB (Peak: 0.6417 MB) Data Comp: Off Server Time: 2026-06-05 05:34:02 UTC
Valid HTML 5 and Valid CSS