|
|
|
|
 Carb identification help needed
#927946
01/28/09 01:23 AM
|
Joined: Jan 2009
Posts: 6
OP
Need a Spot
|
I have been rebuilding my carb, a carter 2 brl, I have looked at some carters online and mine doesn't have the big electrical connector or that pod for adjusting idle I think. My question is does my jeep have the engine control module with the stepper card?
|
|
|
Re: Carb identification help needed
[Re: Joe_cj7_82_Laredo]
#927947
01/28/09 01:57 AM
|
Joined: Oct 2002
Posts: 466
Mudrunner
|
Probably not if it was before '83, or maybe 81. I think the stepper motor went into the 83 and up models about the same time as they went wide track.
Josh
80 CJ-7.
It runs
|
|
|
Re: Carb identification help needed
[Re: jstritec]
#927948
01/28/09 04:47 PM
|
Joined: Oct 1999
Posts: 2,211
Body Damage is Cool
|
82 should have a stepper motor carb run by an ECU computer, but it may have been replaced with a non stepper carter 2bbl.
83 for sure.
SD
|
|
|
|
|
|
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.
PHP: 7.4.33 Page Time: 0.006s Queries: 15 (0.004s) Memory: 0.5938 MB (Peak: 0.6465 MB) Data Comp: Off Server Time: 2026-05-29 23:34:32 UTCValid HTML 5 and Valid CSS 
