Quote
Nice write up Eli <img src="/forums/images/graemlins/kewl.gif" alt="" />
Could you have just raised the rear bumper and not needed to make those cut outs? Last time I looked at mine in the shop I don't thin I had those cut outs or blocks showing. Hmmm... now I am wondering if they even installed mounts in those locations <img src="/forums/images/graemlins/confused.gif" alt="" /> lol


If I remember correctly the bumper will fit over the lifted mounts in the rear, but I don't think it would mount back without some plates/modification. You may be able to drill new holes, but my memory is fuzzy on that.

Quote
Nice work.

Leave the top shroud on. It helps...I think.

Recently did a 2" on the '95. It's much easier on a SWB.

John B.


Yeah I left the top shroud half on because it does help with air flow. I still at some point need to do the radiator drop so I can get the lower half of the shroud back on (if it is still laying around somewhere at Mark's house).

88 Raider(Red):160k-Reman'd 2.6-5spd-Weber-SW Hubs-34x9.5 TSL-OffRd Pkg-1"Tbar-2"BL-CB
88 Raider(Silver):No 2.6/Bad KM145 Parts/Project
88 Montero(Brown):No 2.6,4.88s Parts/Project

[b]4X4 STICKERS,SHIRTS,ETC:
4WD Stickers AT COST.[b]