Eli asked me to add my part of a build and add stuff for the LWB 1st gen Montero. I thought I would start out with what you get when you order the kit.
12x Spacers
12x 7/16in x 4.5in long (Grade 5)
12x Washers
12x Lock nuts



It is not bad set up but personally I want a strong hardware and keep everything metric. So I upgraded the hardware and accounted for the rear 2 bolts, I got longer ones.
10x 10m x 140mm (Grade 10.9)
2x 10m x 170mm (Grade 10.9)
24x Washers
12x Lock nuts



You can see that the metric bolts have a larger head which is a bonus. I will start taking pics of the procedure as I get started. Here is some of the mounting bolt locations. They are not hard to get to. The ones near the seat belt are annoying. This is only 10 of the 12 mounts.

2x mounts are located on the front frame beside the radiator. They seem to be different than the 2dr model. They are kinda annoying to get to and have some kind of paperlike tape covering the holes.


2x mounts are located in the front seat floor board on the driver and passenger side. All you need to do is remove the door seal.


2x mounts are located below the seat belt for the front seats. All you need to do is remove the casing around the seat belt.


2x mounts are located in a hole beside the rear cargo storage boxes. All you do is remove door seal and pull back the carpet around the storage boxes. Watch out for the nasty yellowish brown sticky stuff on the backside of the carpet.


2x mounts are located in the back corners of the cargo area. All you do is pull back the carpet and remove the trim at the rear door

<img src="/forums/images/graemlins/smile.gif" alt="" />