so i took the gauge cluster out to check the plug connections. All looked good, and wasnt that bad to take out,only took me 15min to get it apart. so once that all looked ok i traced the wires back to the power control mod(i think) there were about 5 large plug conections. i refered to my repeir book to see what they went to. 2 obviosly went to the gauges, and 2 other went to the "ccd bus"? any ideas what the bus is? i'm only curious because when the gauges begin to go out the digital odomiter reads no bus.

the gauges are working again for now i found a ground that was looking a bit green. It was the one under the hood next to the fuses in front of the batter.