Oil filter adaptor bolt cross threaded?

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

Oil filter adaptor bolt cross threaded? #938242 03/31/09 04:14 PM

Joined: Dec 2005

Posts: 95

ldrdl

Getting the Wheeling Fever

I tried to remove the T60 bolt for my oil filter adaptor to replace the gasket the other day and I could NOT get it loose. I put a snap on 12mm wrench around the T60 and used a pipe for extra leverage and the only thing that happened was I damaged my wrench. The only thing I can think of is that maybe its cross threaded?!

anyone know for sure?

Entire Thread
Subject	Posted By	Posted
Oil filter adaptor bolt cross threaded?	ldrdl	03/31/09 04:14 PM
Re: Oil filter adaptor bolt cross threaded?	BigJim	03/31/09 07:12 PM

Moderated by 4x4Wire

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.586s Queries: 15 (3.584s) Memory: 0.5933 MB (Peak: 0.6263 MB) Data Comp: Off Server Time: 2026-06-18 14:42:04 UTC
Valid HTML 5 and Valid CSS