Quote
Nice job man! how thick of steel did you use on that and did you just brake it all or cut and weld each panel? either way it looks great, almost factory


Its made out of 1/8" steel plate. The square tubing that was the foundation had 45 degree notches put in it so that we could bend it around and still get the nice radius bend under the tail lights. The panels ont he bottom are cut and welded and the one directly under the tail light is done with a break to get the nice round radius. The main mounts are 1/4" where the hitch reciever is and it mounts to the tow hitch points. Hope this helps

Phil

03 Montero XLS, OME 2"suspension lift,Full skid plates, Extended Diff/transfer breathers. 34 LTB's, Winch w/syn rope, Locked front/rear.