I just put the body blocks, haven't done anything else yet. I'm trying to get off work earlier today to finish the lift.

I could not find M14x1.5 coupling nuts to built the extensions, so I had to go to a machine shop. It was not cheap, it cost me 160 bucks to get them fabricated. I asked them to make the extensions 4" long, so I can keep the rubber doughnuts.

I bought a metal grinder to cut the floor (4wd shifter) and I'm expecting to be able to extend the shaft linkage under the car (gear shifter). The fuel fill line need to be replaced with a longer one. I forgot to mention that I loosened the fuel filler and vapor line prior to lifting the body. I don't know about the exhaust, haven't paid attention to that. The bumpers will be another challenge for me, since I don't have a welder. I think I can use brackets and bolts.

I will post some pictures, as soon as I figure put how to do so.

Thanks