I'm looking for an output shaft seal form the front of my truck, dif side (left). It is a 91 Pajero, which typically cross refferences with a 92 Monty. Since I'm up here in Canada and the Gen II was never available up here I'm having trouble tracking down the part number, or the part for that matter. Any help would be appretiated. So far I know this:
Nation Oil Seals part #710213 or maybe 710146 or maybe 710151. The CRH number is 24283. (so basically I don't know the part number)

From what I can tell (based on research) the seal dimensions are:
Shaft 2.441
Bore 3.071
OD 3.08
Width 0.276

If anyone can confirm any of this I'd appreciate it. Right now it's looking like I'll have to put up with the leak and just keep an eye on it. I also have some friends with CAPS that are double checking part numbers for me.

I think it's the same as the rear output shaft seal. Try looking that one up.

just recently replaced both seals on my rig and my son's..

the part number stock from mitsubishi is MD 712012 and MD 731708...

this should be the same but i do not guarantee...

both of our rigs are 1989 gen 1 with manual tranny...

Thanks guys, I'll try those numbers. I'm avoiding the Mitsu dealerships in town right now, they seem to have a thing against right hand drive vehicles. Based on the bad service I received today I'm assuming that the recession really is over and that customers are falling out of the trees with money in hand.

Thanks again.

Maurie