slave cylinder

4x4Wire Trail Talk Forums: Jeep, Toyota, Mitsubishi, Pajero, Isuzu, Kia, 4WD, 4x4, SUV, Off-Road and OutdoorWire Forums

Print Thread

Rate Thread

slave cylinder #960741 08/26/09 03:54 PM

Joined: Sep 2000

Posts: 393

Seattle, WA

Lor

Mudrunner

I got the tranny swapped and was installing the slave cylinder. Can't seem to put the unit on. The piston was way out, and I couldn't push it back. Has anyone experience this? Do I need to open the pressure and then push it back? Bad cylinder? Can't wait to get her running. Thanks for any tips/helps.

Entire Thread
Subject	Posted By	Posted
slave cylinder	Lor	08/26/09 03:54 PM
Re: slave cylinder	fasteddy	08/26/09 05:36 PM

Moderated by 4x4Wire, Macka, Mudraider, off-roader, PHIL_, rxinhed

Hop To

4x4Wire Social:

| 4x4Wire on FaceBook |

OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting.
Copyright (c) 1999-2019 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission
You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material.
All corporate trademarks are the property of their respective owners.

PHP: 7.4.33 Page Time: 3.941s Queries: 15 (3.939s) Memory: 0.5940 MB (Peak: 0.6270 MB) Data Comp: Off Server Time: 2026-07-16 20:59:32 UTC
Valid HTML 5 and Valid CSS