First let me say I still cannot figure out how to search for old post on this site!!! <img src="/forums/images/graemlins/confused.gif" alt="" /> Need some insight from the pros on here. I'm working on the front brakes and wheel bearings on my '94 4x4 Yota. I got the whole assembly apart and after taking a look at the bearings and races I'm on the fence if they need replacing. No pitting on either the bearings or races, but the races show some, well they look very lightly scratched, no groves though. Bearings show some of the same, but much, much lighter, then the races show. The inside of all the bearings all have to some degree a discoloration/wear as well as the spindle itself. The grease on the right was looking pretty old and the left seemed like there should have been more. Service on the bearings is a bit overdue, so I'm thinking the safe thing is to replace the bearings, but I'm not sure. What do you all think? What should I do about the discoloration on the spindle? Rear seals looked great, cleaned up real well, planning on re-using.

Oh on reassembling should I put some grease in the void between the inner and outer seal? If so how much is enough? Don't want to over do it. And the locking hub assembly looks to have some type of grease applied there, but my Hanes manual doesn't mention re-greasing it. Any thoughts?

Thanks a ton <img src="/forums/images/graemlins/cheers.gif" alt="" />