As I recall Capt.Crunch used 2 shims on his Gen 2 UCA installation into his 2.6 SWB with long shackles on a leaf spring rear. Also in case you haven't notice the Gen 2 arms have a thick side and thin side where the Gen 1s are the same both sides. He didn't crank his bars enough to level it out. I don't think you can crank them far enough to level out on a SWB OME coil or Gen 2 coil setups.

The Question is for me ::::

????????just how far should I crank them and what's the best way to measure from other than from the fenders (like Phil did in his writeup on the Mitsu Page) ,,, to get both Tortion Bars set the same tension????????

dave h.
'89 Raider V6 5spd;Aisin Hubs;; Gen2 LS: frt. brakes, rear coils;U.C.arms;R.trailing arms;idler arm; rear LSD axle w.disc brakes ;2 battery system for Dog's fan; relocated ECU; custom bumpers;J.Baker receiver;Conferr roofrack; t-bar crank.