Got the front end back together... just need to bleed the brakes and get it aligned... turning it around and starting on the rear end!



A few notes:

FSM is great for torque spec's / etc. Must have.

Do NOT buy mevotech parts!!! the LCA bushings were fine, but the tie rod ends are GARBAGE!!!

here is my front suspension parts list:

- Energy suspension bushings (upper)
- Mevotech lower bushings (will swap to the energy one day, when i have the energy...ahhhh)
- Energy suspension sway bar bushings and end links
- Sankei 555 upper and lower BJ's
- BJ spacers and sway bar drop
- OEM yota inner tie rods
- TRW (sankei 555) outer tie rods
- koyo front wheel bearings
- new oem gaskets / seals for hubs
- Redline synthetic high speed MP grease (for wheel bearings and hubs)
- Beck arnley inner oil seal (made in japan) - mine were completely gone!!!
- OEM toyota backing plates
- OME front shocks
- Goodridge stainless braided lines
- Powerslot rotors
- Hawk LTS pads
- New caliper hardware (centric)
- New oem toyota LCA adjusting bolts / nuts... 1 had to be cut out, others were very rusty
- CK truck parts nylon steering stops (ebay... should last 100x longer than stock)
- Would like to get power steering box rebuilt, and TC idler arm... next year...