No problem as at all. Clarification is good. <img src="/forums/images/graemlins/kewl.gif" alt="" />

I was generalizing using inches.

The image posted is the correct dimensions.

25mm high side / 22.5mm low side = 2.5mm taper spanning the diameter of the whole spacer.

Bolts are 10M x 1.25 x 45mm / fine thread pitch / Grade 10.9 (metric equivalent of Grade 8 SAE) with 10.9 grd washers.

There is a sheet with detailed instructions on how to install them, a disclaimer and note to have a wheel alignment done after the install.

I have 8 sets left. I'm starting to ship them over to the UK as our dollar is low and they are saving 1/2 off buying them from Australia.