Made up some sliders out of 50mm...nevermind 2" square tube with 3/16ths wall thickness. They're pretty stout. I wanted something quite subtle for convenience as it's a DD. I made the kick out at the rear by cutting a slit just behind the outside face (top and bottom) and then pulled the outside face out. I then filled the gap with plate and capped both ends.

Mock-up

[Linked Image]

[Linked Image]

After paint

[Linked Image]

[Linked Image]

Seem to do the job OK. They don't flex at all <img src="/forums/images/graemlins/smile.gif" alt="" />

[Linked Image]

'97 Montero 'LSR' - 4.6 gears & factory rear locker, 33" Procomp muds on 15x8 steelies, 50mm coil spacers, T-bar crank, Airlift, sans rear sway, 50mm rear frame & fuel tank lift, Aisins, ARB front bumper + 10k lb winch, 50mm DIY body lift, rock sliders, cut rear quarter panels...