Quote
Quote
Thanks Charlie. So if I flare the end of the pipe, the flared edge won't eat away at the inside of the hose?

One idea I had was the cut a ring off the end of the pipe, split it so it will fit over the end of the pipe and solder in place. Think that would work?

Yes, and correct the flair has to be minimal so as not to damage the hose.


<img src="/forums/images/graemlins/kewl.gif" alt="" /> Thanks

'97 Montero 'LSR' - 4.6 gears & factory rear locker, 33" Procomp muds on 15x8 steelies, 50mm coil spacers, T-bar crank, Airlift, sans rear sway, 50mm rear frame & fuel tank lift, Aisins, ARB front bumper + 10k lb winch, 50mm DIY body lift, rock sliders, cut rear quarter panels...