OH MAN!!! it's been a long time and lots of haze gray and underway (Navy Lango) since i've posted any updates. Well i've got the c6 and the np205 installed .....sorta, and i finally built the cross-member for the tranny tonight so the engine and the tranny are supported finally by the vehicle and not a host or jack. the engine is only tacked in place till I make sure all is well in the alignment world, as for the tranny i'll have to do a lot of cutting if this design for the cross-member dosnt work out.
PIX PIX PIX!!!!!



















And as always im open to ideas and suggestions, its fun building a truck but i just dont have any one to share the build with down here.
<img src="/forums/images/graemlins/cheers.gif" alt="" />