Quote
Is the SA shaft designed not to pull apart? All the IFS shafts I have the female splines slip right off. Will the CV joint on the SA shaft handle sharper angles than clearancing the IFS CV joint? I'm rotating the axle housing 9.5 degrees to help improve the CV angle also. The spacer is a good idea cause I figure my axle will be 2" further forward due to the rear springs.

Thanks for the links 4Crawler and thanks everyone for the advice.


The SA shaft will pull apart like any other shaft, not sure if there is any difference in spline/slip length between the two shafts. Angle the CV operates at will depend on how much you clearance the inside of the CV joint, I think both joints can end up about the same travel.

r.c.brown@ieee.org
TruckEditor@tlca.org
Project: 4Crawler
4Crawler OffRoad - 4x4Wire discount code