Saw your PM before the post here. Here's the reply for anyone who is following...

Right, where the jack is. We have come to refer to them as smuggler's cubbies. The whole front edge to them, both doors, etc., is one big piece under the carpet. You want that piece, and ideally the nuts for the studs that the seat bolts to. You could do it without this, I'd say, but it would be a lot more work to get everything to line up.

Take a look at your seat now. It hinges on the front and locks down to two hoops rearward that are at the outside edges. For the split seats, there is a similar hoop in the middle that they share. You need that from the donor too.

Is this person parting out a truck then? Is it an SR? Go for the rear axle if it is.

Big Truck: 00, 3.5, Endeavor, 5-Spd drive line in hand!
Little Truck: 87, 2.6T I/C, MT, LSDs, Tonneau Top
Her Truck: 03, 3.8, 20th Anniv, 65k
Daughter's: 06 Eclipse, Keeping it Mitsu!
FSMs: MitsubishiLinks.com