Well, where to start? I have a complete fab shop at my disposal. it was ready to go into production. All the negative feedback discouraged me. But only a little. I had it set up to mount toyota upper control arms--- scrapped--- built upper tubular arm to recieve torsions. still debating wether to use those in the kit or coilovers. I am now starting almost from the begining. the rears are 2x3 3/16 box sliders with a coil made by pol spring. at this time i have driveshaft spacers 2" upgradable to extended drive shafts. i have strut braces that mount from the rear of lift above lower control arm to the frame. with this kit it offers great clearance for 38" tires room to tuck. i hate body lifts. i really dislike negative feedback. if you have any ideas or design suggestions i am completely open. if you are not interested go read another post. Oh and thank you for all the positive feedback and ideas.