Just installed a boost gauge and a pyro along with my meth injection and I made some EGR block off plates. I'm going to see if I can book a run on the dyno to lay down some stock numbers as well as some with meth sprayin and some increased boost. It seems my wastegate actuator is set for just over ten pounds boost, my 2.5 was 12PSI when stock, anyone else with a 4M40 and a boost gauge to compare stock boost with?? It also gets to 1300*F rather quickly. I'll do a run with the meth tomorrow and see what kind of a difference it makes, didnt quite finish the wiring tonight so testing will wait untill tomorrow. So far I'm quite impressed with the stock power when compared to my modded 2.5, I can't wait to really step it up.